Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Config L2TP VPN Clients along with IPSec Clients and Site-2-Site

Is it possible for the PIX to handle L2TP, Cisco VPN Client, and Site2Site IPSec configurations all with pre-shared keys? If so, where might I find a config example.

We currently have a home to branch office site2site IPSec tunnel, along with Cisco IPSec VPN Clients setup. I'd like to add the ablity for clients to connect with a pre-shared key via L2TP (e.g. via a mobile device such as WM5).

Thoughts? Suggestions?

  • Other Security Subjects
3 REPLIES
Gold

Re: Config L2TP VPN Clients along with IPSec Clients and Site-2-

Jeff,

Does the follwing link help....

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a0080093f89.shtml

Also, here's a very good document from Zander Networks on how to setup L2TP on Cisco PIX.

http://www.zandernetworks.co.uk/technotes/Tech%20Note%2004.pdf

Please remeber to rate post if it helps,

New Member

Re: Config L2TP VPN Clients along with IPSec Clients and Site-2-

I actually already have a copy of the docs above.

After further thought, this has more to do with whether a single transform set can handle tunnel and transport mode.

Or rather, how does one setup transport mode for L2TP, when Cisco VPN Clients and Site2Site VPNs terminate on the same interface.

New Member

Re: Config L2TP VPN Clients along with IPSec Clients and Site-2-

I figured it out. Multiple transform sets with the dynamic-map command.

crypto dynamic-map dynmap 40 set transform-set [trans#1] [trans#2]

256
Views
0
Helpful
3
Replies
This widget could not be displayed.