Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

config of active/active ASA5520 for Voice and data

Hi, I have to configure 2 ASA5520 in a hight-avaibility setup for voice and data. I have some questions: in the multi-context mode can I apply QOS on logical interface ?

Does somebody have an example config using:

2 context (for load balancing) and 4 network interfaces ?

Thanks

2 REPLIES
Silver

Re: config of active/active ASA5520 for Voice and data

Cisco Employee

Re: config of active/active ASA5520 for Voice and data

Francis,

My understanding is, QoS is not supported in Multi-Context Mode.

I dont see any options such as class, priority-queue or service-policy in Multi-Context Mode. So, I am pretty confident that this feature is not supported.

I checked the below doc on www.cisco.com but did not see QoS as one of the Unsupported Features. Well, in a practical world, I dont expect the doc to have all the unsupported features.

http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_70/config/contexts.htm#wp1116132

I hope it helps.

Regards,

Arul

168
Views
0
Helpful
2
Replies
CreatePlease to create content