Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Cisco Support Community site will be in read only mode on Dec14, 2017 from 12:01am PST to 11:30am for standard maintenance. Sorry for the inconvenience.

New Member

config syntax and instruction execution order

conf t

...

service virtual-sensor-configuration virtualSensor

tune-micro-engines

systemVariables

FragmentReassembly

IPReassembleTimeout nnn

MaxPartialDatagrams nnn

MaxFragmentsPerDgram nnn

ReassembleMaxFragments nnn

exit

StreamReassembly

TCP3WayHandshakeRequired ''

TCPReassemblyMode ''

TCPOpenEstablishedTimeout nnn

TCPEmbryonicTimeout nnn

exit

exit

exit

Doing this out of memory, and am having some difficulty in remembering syntax and instruction execution order. I want to modify the variables above through the cli, in one shot. I get an err at MaxPartialDatagrams nnn.

Is the syntax and the order of instruction execution correct? Could someone step through the above and let me know?

1 REPLY
Cisco Employee

Re: config syntax and instruction execution order

It should be possible to make and apply a group

of cli commands in one shot. But there are

numerous syntax errors in your example.

Try making the changes manually, and then

combining those cli commands into a cli script.

For example, systemVariables is a mode command,

and should either be completed and exited or

removed from the script. MaxPartialDatagrams

and MaxFragmentsPerDgram are not configurable

elements. ReassembleMaxFragments should be

IPReassembleMaxFrags. TCP3WayHandshakeRequired

and TCPReassemblyMode do not take '' as param

values. The last exit should be replaced by yes.

92
Views
0
Helpful
1
Replies
CreatePlease to create content