Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Configure command (conf net) not working anymore...

I had built a web-based app to allow our network admins more easily administer our PIX, which used the conf net command to suck down configuration changes from a tftp server. After upgrading our PIX's software from 5.2.3 to 5.2.8, it doesn't appear to be a valid command.

I had used:

conf net xxx.xxx.xxx.xxx:filename

is there a way to make this work again, possibly with a different command?

1 REPLY
New Member

Re: Configure command (conf net) not working anymore...

Conf net, to my understanding does not work again until version 6.2 which was just released.

Good Luck.

236
Views
0
Helpful
1
Replies