Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Configure PIX for VPN

To configure the PIX 50x firewall for supporting the VPN, I have two questions:

1)Is the configuration web-based? i.e., I only need a PC connect to the firewall equipment, then start the configuration via my PC's web browser (using wizards)?

2.Do I need a CD to install some software on my PC for this purpose (configuration of the firewall?

Thanks

Scott

2.

1 REPLY

Re: Configure PIX for VPN

YES, you can use the PIX Device Manager (PDM) to configure your PIX Firewall. There is a VPN wizard that helps you to setup your VPN settings.

You just need a browser with JAVA and cookies enabled then it should rock.

https://192.168.1.1

See PDM Guide:

http://www.cisco.com/en/US/partner/products/sw/netmgtsw/ps2032/products_installation_guide_chapter09186a008017a423.html

http://www.cisco.com/en/US/partner/products/sw/netmgtsw/ps2032/

I personaly do not touch the PDM I prefer using command line (CLI) to have control over the PIX.

sincerely

Patrick

104
Views
0
Helpful
1
Replies
CreatePlease to create content