Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

configure vpn in pix with 7.2 version

Hi All,

I am having a problem in configuring a dynamic VPN in my pix which has the 7.2 version of ios but i am able to work with same configuration in the pix whch has 6.3 version i just want a user from outside my network using the vpn client access the resource inside my network below is my configuration is it ok are should i need to do anything more? please advice me.

ip local pool vpnpool1

crypto dynamic-map map2 20 set transform-set guatemala1

crypto map map1 20 ipsec-isakmp dynamic map2

crypto ipsec transform-set guatemala1 esp-aes-256 esp-sha-hmac

isakmp policy 20 authentication pre-share

isakmp policy 20 encryption aes-256

isakmp policy 20 hash sha

isakmp policy 20 group 2

isakmp policy 20 lifetime 86400

vpngroup Guatemalavpn address-pool vpnpool1

vpngroup Guatemalavpn split-tunnel inside_nat0_outbound

vpngroup Guatemalavpn idle-time 36000

vpngroup Guatemalavpn password xxxxxxx

access-list outside_acl permit tcp

route outside

access-list inside_nat0_outbound extended permit ip any

access-list inside_nat0_outbound extended permit ip

access-list 102 permit ip

nat (inside) 0 access-list inside_nat0_outbound


Re: configure vpn in pix with 7.2 version


I submitted the necessary info on firewalling section