Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

configuring 2 locations with dot1q trunking and ezvpn

Hello,

I've got the following isue, i'm connecting a site to the HQ, on the site we have to use dot1q trunking on the fastethernet from the 1721. We've been trying to make a ipsec tunnel to the HQ through EzVpn, after some major problems, (first we had to upgrade the ios to 12.3 because we couldn't define an inside interface so we got a default route to the site, which would have been fine, wasn't it so that we have to connect multiple site's). Then we ran into another problem: Momentarely it's only possible to define 1 inside interface on subinterface's (which we have to make regardig the dot1q trunking). Does anybody know of another solution so we are able to make vpn's to the concentrator and still can do vlan routing on the remote site's?

1 REPLY
Bronze

Re: configuring 2 locations with dot1q trunking and ezvpn

I don't think there's any work around to this problem.

114
Views
0
Helpful
1
Replies
CreatePlease login to create content