Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configuring a DMVPN with DSL for Backup.

We currently have 2 locations one in the US and one in the UK, and these are connected to a point to point T1/E1 and running fine. We want to add a backup to this just in case of an outage. We went with a cable connection in the US and a DSL in the UK. I have the cable connection going to an Ethernet port on in the US and a WIC-1ADSL installed in the router in the UK. By the way both routers are 2811's. We have a static IP in the UK and for some reason they can't give us a Default Gateway and we have a static IP here in the US as well. All that being said I can't get the tunnel to come up. Here is the code I entered in the UK for the DSL.

interface ATM0/1/0

no ip address

no atm ilmi-keepalive

dsl operating-mode auto

pvc 8/48

encapsulation aal5mux ppp dialer

dialer pool-member 1

!

!

interface Dialer0

ip address negotiated

encapsulation ppp

dialer pool 1

dialer idle-timeout 0

dialer persistent

dialer-group 1

keepalive 5

down-when-looped

ppp authentication chap callin

ppp chap hostname blah@blah.com

ppp chap password blah

!

dialer-list 1 protocol ip permit

Anyway any would be appreciated.

Regards,

D

2 REPLIES
New Member

Re: Configuring a DMVPN with DSL for Backup.

If you want to configure DMVPN using DSL as a backup it works great! We are doing it running EIGRP. What protocol are you running over your WAN?

New Member

Re: Configuring a DMVPN with DSL for Backup.

We are EIGRP.

Can you give a rough idea of the config because I am getting nowhere.

151
Views
0
Helpful
2
Replies