Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configuring a peer in PPTP

Is it possible to specify the peer's IP (for security purposes) when configuring a PPTP tunnel terminating in a PIX Firewall ?

I've tried to do this with an access-list but the PIX doesn´t let me configure a rule that starts and terminates in the same interface....

Comments appreciated, thanks!

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: Configuring a peer in PPTP

Hi there,

You cannot really restrict the PPTP user on the pix firewall itself. What you can do to achieve the same results is do define an ACL on the Interner router ( the router which acts as the default gateway on the pix) and apply that ACL on the interface connected to the outside interface of the pix

Hope that helps

Jazib

1 REPLY
Bronze

Re: Configuring a peer in PPTP

Hi there,

You cannot really restrict the PPTP user on the pix firewall itself. What you can do to achieve the same results is do define an ACL on the Interner router ( the router which acts as the default gateway on the pix) and apply that ACL on the interface connected to the outside interface of the pix

Hope that helps

Jazib

83
Views
0
Helpful
1
Replies
CreatePlease login to create content