I am about ready to pull my hair out after 3 reinstalls. here is some background... I attempted to upgrade to 3.1 from 3.0.0 but was unable to because of pending jobs that did not exist, so I had to uninstall 3.0.0 (after I backed up) and then installed 3.1. I attempted to restore the back up but that flopped. Anyway, I need to know how the heck I get the IPS management center configured/installed/whatever so I can use it from the web page. What would be even BETTER is if I could get the backup to restore.
If anyone could help, that would be great. I have seen absolutly nothing in the documentation for 3.1 that helps me.
Re: Configuring IPS managment center on CSM 3.1???
There is a problem with the upgrade from 3.0 to 3.1 when there are pending activities that have not been submitted to the database. IPS is also a native service in 3.1 and does not use the IPS Management Center. You should be able to add the IPS devices to 3.1 and not use the 3.0 database.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...