Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Configuring PIX 501 with ISDN DialUp Connection

Hi,

I'd really appreciate if someone could help me with the following scenario:

I need to configure the PIX 501 to work in the following network setup

LAN ---> PIX 501 ---> Cisco 760 ISDN Router ---> Internet

The LAN I have is very small, having 11 users on Static IPs, with a WinNT 4 server (LAN's IP range is 192.168.0.x)

The internet connection is a 128Kbps DialUp connection.

We get a Dynamic IP address from the ISP everytime there is a new connection.

How do I set up the PIX 501? and do I need to change anything on the Cisco 760?

Thanks.....

1 REPLY
New Member

Re: Configuring PIX 501 with ISDN DialUp Connection

This will be an easy do for you. There are just a couple of things you will have to do that will be different from the standard out of the box config.

1) Give the outside interface of the 501 a static IP [ip address outside 192.168.1.1 255.255.255.252]

2) Turn off NAT on the PIX [nat (inside) 0 0 0]

On the 760,

1) enable NAT (actually PAT) [ip nat inside source list 1 interface BRI0 overload]

2) Give the ethernet interface an IP address to match the PIX [router#(config-if) ip add 192.168.1.2 255.255.255.252]

3) Add a static route to your inside network [ip route 192.168.0.0 255.255.255.0 192.168.1.1]

That should do it!

Bob

83
Views
0
Helpful
1
Replies