This is just a basic PIX config with multiple DMZ interfaces. You need to first give the DMZ interface a subnet and an IP address specifically. This can be anything really, but usually you'd use a private IP subnet like 10.x.x.x or 172.16.x.x or something like that. So, you'll use the command:
> ip address dmz 10.1.1.1 255.255.255.0
Note that "dmz" is the name of the interface, which you can specifiy using the "nameif" command, you'll see these at the top of your PIX config, the interface names will default to pix/intfx unless you change them to something else more meaningful to you.
Then you can put your hosts on this segment and give them 10.1.1.x IP addresses, with a default gatewya of 10.1.1.1 (the PIX interface).
Then to allow traffic from the outside to a DMZ interface, you need a static and an access-list. Something like the following:
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...