Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configuring privilege issue

Hi,

I need some advice here. I am trying to configure a router for access privileges.

Following is the configuration:-

enable secret level 14 5 $1$yQtt$0yL38AHKDnpuLO3MMaGi3/

privilege configure level 14 interface

privilege configure level 14 interface shutdown

privilege configure level 14 interface no shutdown

privilege configure level 14 interface ip address

privilege configure level 14 interface no ip address

privilege exec level 14 show run

privilege exec level 14 configure terminal

privilege exec level 14 show startup

Problem is that though user can login in access level 14 but he faces two issues:-

1. sh run output is appears only as

Building configuration...

Current configuration : 80 bytes

!

!

!

interface Tunnel0

!

interface FastEthernet0/0

!

interface Async5

!

!

end

But sh startup is completely shown with all the information.

2. User can enter interface config mode but if he tries to configure ip address or shutdown interface, it doesn't work.

Any help will be greatly appreciated.

--Noman Bari

2 REPLIES

Re: Configuring privilege issue

Hi Noman Bari

AFAIK all config related commands can be executed only from privilege level 15.

Even Show run in any other privilege level except level 15 will fetch you the above output only.

regds

New Member

Re: Configuring privilege issue

Hi kumar,

Thanks for your response and helping out..while tweaking around my initial posting, i stumbled upon what worked for me and this works now..

--Noman Bari

102
Views
4
Helpful
2
Replies
CreatePlease login to create content