cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
794
Views
0
Helpful
1
Replies

Configuring the PIX 520 with two links to the Internet

jjcarranza
Level 1
Level 1

hi.

i have a pix firewall 520 with four ethernet interfaces, actually i'm using

just two interfaces,,,,

ethernet 0 outside

ethernet 1 inside

ethernet2 intf2 shut

ethernet3 intf3 shut

so, in the interface outside i have the access to the internet, but now i have

a new access to the internet and i want to configure both, i mean,

one single network in the inside and two access to the internet,

is it posible???,,,,,,,

the configuration maybe,,,

ethernet 0 outside (access to internet 1)

ethernet 1 inside (ip 10.1.1.1)

ethernet2 outside2 (access to internet 2)

ethernet3 inside2 ???? (ip 10.1.1.2) ?????

thanks for the help,

1 Accepted Solution

Accepted Solutions

kdurrett
Level 3
Level 3

You can connect it that way but there's no way to route default traffic. Pix doesn't support this type of connections as you can only configure one default route on the pix. This link should help describe what you can do: http://www.cisco.com/warp/public/110/pixfaq.shtml#Q18

Hope this helps.

Kurtis Durrett

View solution in original post

1 Reply 1

kdurrett
Level 3
Level 3

You can connect it that way but there's no way to route default traffic. Pix doesn't support this type of connections as you can only configure one default route on the pix. This link should help describe what you can do: http://www.cisco.com/warp/public/110/pixfaq.shtml#Q18

Hope this helps.

Kurtis Durrett

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: