Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Cisco Support Community site will be in read only mode on Dec14, 2017 from 12:01am PST to 11:30am for standard maintenance. Sorry for the inconvenience.

New Member

Connection & Embryonic Limit

Are there any standards for setting these figures? The servers are domain controllers, web servers, mail, and file & print.

thanks,

biz

1 REPLY
New Member

Re: Connection & Embryonic Limit

Every network is different. So it is impossible to have a “standard”. You need to due a baseline of your network. Take a good look at the Embryonic and connections for each translation. Just make sure you don’t set the limit to low (this will stop valid traffic as you already know). I recommend setting both of them high then gradually lowering them...

-Brett

97
Views
0
Helpful
1
Replies
CreatePlease to create content