Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

connection problem

I use IDSM2. The IDS device and host server was in different VLAN but with same netmask.

i can ping the ip address but i can't open ids device manager through web site(https://ipaddress). In IDSMC monitoring (VMS) there is no connection.

When i try to add sensor with Discover Settings, there is an error :

" Error importing configuration files from the sensor-Can not get the type of sensor. Remote process exit code unavailable"

this is my configuration with CLI :

sh conf

! ------------------------------

display-serial

! ------------------------------

service Authentication

general

methods method Local

exit

exit

exit

! ------------------------------

service Host

networkParams

ipAddress xx.yy.zzz.c (VLAN 1)

defaultGateway xx.yy.zzz.ccc (VLAN 1)

hostname IDSM2

telnetOption enabled

accessList ipAddress xx.a.bbb.d (VLAN 2) netmask 255.255.255.0

exit

optionalAutoUpgrade

active-selection none

exit

timeParams

summerTimeParams

active-selection none

--MORE--

exit

exit

exit

! ------------------------------

service Logger

masterControl

enable-debug false

exit

zoneControl zoneName Cid

severity debug

exit

zoneControl zoneName AuthenticationApp

severity warning

exit

zoneControl zoneName Cli

severity warning

exit

zoneControl zoneName ctlTransSource

severity warning

exit

zoneControl zoneName IdapiCtlTrans

severity warning

exit

zoneControl zoneName IdsEventStore

--MORE--

severity warning

exit

zoneControl zoneName MpInstaller

severity warning

exit

zoneControl zoneName tls

severity warning

exit

exit

! ------------------------------

service NetworkAccess

general

allow-sensor-shun false

shun-enable true

exit

exit

! ------------------------------

service SshKnownHosts

exit

! ------------------------------

service TrustedCertificates

exit

! ------------------------------

service WebServer

--MORE--

exit

! ------------------------------

interface group 0

sensing-interface int7

sensing-interface int8

exit

interface sensing int7

exit

interface sensing int8

exit

_______________________

Group 0 is up

Sensing ports int7,int8

Logical virtual sensor configuration: virtualSensor

Logical alarm channel configuration: virtualAlarm

what's wrong with my configuration ?? can someone here help me please..

2 REPLIES
New Member

Re: connection problem

From your configuration it seems you have two Vlans on the switch. Are the Vlans configured in the same group / trunked ?

Also did you configure the Blade with the default 443 port?

Cisco Employee

Re: connection problem

The problem is likely that your accessList is using a single address with the netmask for a network.

If you are only allowing a single address then leave the netmask dsignator off the configuration line, or set it 255.255.255.255 (all 255s).

Only use a 255.255.255.0 netmask if you designate the subnet address not a single address.

So for example for a single address:

accessList ipAddress 10.1.1.1

or

accessList ipAddress 10.1.1.1 netmask 255.255.255.255

For the entire 10.1.1.0 network is the only time you would use the 255.255.255.0 netmask

accessList ipAddress 10.1.1.0 netmask 255.255.255.0

79
Views
0
Helpful
2
Replies