Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Connection slow to terminal server through of Pix

Hello,

I have slow connection speed with a terminal server located in a remote network, the pix are installed in my local network and the another side, the server without firewall; when I connect without pix, the connection is fast, but I´m connect the pix in my network this connection is very slow when send the login message in the remote server.

Thanks for your comments,

Manuel Domínguez

1 REPLY
New Member

Re: Connection slow to terminal server through of Pix

Hello Manuel,

This problem might indicate an error on NIC from the pix, or on the server. Set default value of all NIC to 100full. Sometimes leaving auto-negociate value will cause error while negociating speed and duplex between pix and host. Also check for any error on subnet mask.

On the pix does the "show interface" command report any error?

Hope this help;

Mike

242
Views
0
Helpful
1
Replies
CreatePlease to create content