I installed 3.0(2)S9 on my sensors and updated my CSPM. CSPM verifies the sensors as 3.0(2)S9 and updates that attribute for them. However, when I go to push out a configuration to them I get the error: "Specified IDS Sensor Version 3.0(2)S9 is not an exact match to a supported version. All features may not be supported." At this point I cannot push out a configuration to the sensors. Doing "nrvers" on both sensors shows them as 3.0(2)S9. I have looked around trying to understand how the version doesn't match. On both sensors in /usr/nr/etc/configd.conf I see it showing a wrong version there. One lists 3.0(1)S5 as the version and the other sensor lists 2.5(1)S2.
My question is, is this what's causing my problem? If it is, can I just go into the file and type the right version or will I need to go through some other process?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...