Re: Creating signatures for a particular source port
With version 2.5(1)Sx and earlier versions there is not the ability to create custom signatures and there is no signature matching your requests.
However, in 3.0 sensors there will be the ability to create custom signatures. You may be able to create custom signatures which come close to what you are asking.
Once 3.0 comes out this summer then you can give it a try, and if you have difficulty then repost the question and I can try to help with some specific examples and instructions. I can not give these examples out right now since 3.0 has not yet been released.
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...