Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Creating trunk between PIX and CatOS

I have been attempting to creat a trunk between a PIX and CatOS. The only VLANs on the trunk are 11 and 20. I've tried the following, but it didn't work. Any ideas? Thank you.

PIX:

interface ethernet1 vlan11 physical

interface ethernet1 vlan20 logical

...

nameif ethernet1 inside security100

nameif vlan20 mct security60

...

ip address inside 192.168.11.254 255.255.255.0

ip address mct 192.168.20.254 255.255.255.0

Catalyst:

Set trunk 4/34 on dot1q 11,20

1 REPLY
Bronze

Re: Creating trunk between PIX and CatOS

the PIX is right, check the speed configuration at PIX (interface ethernet1 auto)

90
Views
0
Helpful
1
Replies