I mean there is a dialog prompted when the network connection is disconnected. And I must manually press the OK button of the dialog and then the VPN will start to automatically connect.
I am using 5.0.05.0290 of VPN client. And IKE keep alive has already been enabled.
I have tried to use "vpngui.exe /c /sd" to enable the vpn to auto connect during Windows logon and does not prompt the "Disconnect Dialog" when the VPN terminated by some reason. But it cannot reconnect after the vpn terminated by network interruption when using this method. And the VPN Auto initiation has already enabled in VPN Client Console before using "vpngui.exe /c /sd".
"I was eventually able to get this going. I remembered back from the past a program called PTFB, or Push The Freakin Button. This program can be trained to click on annoying prompts automatically without the user have to be present to do it. I also found that you can launch the Cisco VPN gui from a command line with the username and password.
So what I did was create a batch file that is scheduled to run with the following command;
DocumentationCode download linksGoalRequirementLimitationsSupported ISR and UCS-E ModelSupported ISRG2 and UCS-E Blades:Supported ISR4K and UCS-E Blades:Step by Step ConfigurationConfigure one of the connectivity options to access the Cisco IMC from the n...
Firepower Threat Defense (NGFWv) on UCS E-series - Transparent Mode in HA
DocumentationCode download linksGoalRequirementLimitationsSupported ISR and UCS-E ModelSupported ISRG2 and UCS-E Blades:Supported ISR4K and UCS-E Blades:Step by Step ConfigurationCo...
I am currently unable to specify "crypto keyring" command when configuring VPN connection on my cisco 2901 router.
The following licenses have been activated on my router :