I have hub-and-spoke vpn network. The hub is a PIX with crypto map configuration. Now I'm adding new spoke device which is configured with VTI. Debug shows that IPSec cannot be established because of proxy address mismatch. Hub's crypto map acl is "permit ip any 10.x.y.0/24". VTI proxy is "permit ip any any" by default.
I've read in documentation that proxy address can be changed on DVTI. How can I do that? There're no examples in documentation.
How can I set proxy address on the spoke to "permit ip 10.x.y.0/25 any"?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...