CSA 5.1 (Error: Creating Registry access control rule)
I'm not in front of the CSA MC so this was a difficult question for me to field, though I am hoping that I am simply overlooking the obvious. ;-)
If you get an error when using the Event Management Wizard to create a Windows registry access control rule and it states to see the log file for details, then where do you look? I can't remember and none of the pull down menus seem to offer an answer.
Here it is in all its glory:
Error: Creating Registry access control rule. Error (see log file for details)
11/6/2006 10:46:42 AM cnxdc2.cnsl.com Alert TESTMODE: The process '<remote application>' (as user CONSOL\CNXCONTROLM$) attempted to access the registry key '\REGISTRY\MACHINE\SOFTWARE\Microsoft\Windows NT\CurrentVersion' and value ''. The attempted access was an open (operation = OPEN/KEY). The operation would have been denied.
Details Rule 57 Wizard
1265 similar events (same Type/Rule ID/Application)Find Similar
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...