Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CSC - Cant get access to management port

Good Morning

I have an asa 5510 running content security filtering, however when I try and get access to the content security management interface to configure it I am asked for username and password and get the error that the IP Address of the management interface is unreachable. Check the management port settings and network connectivity.

However the management interface was set up on 10.x.x.x and you can ping this address from the ping command within the firewall.

here are the details of the csc module

ASA 5500 Series Content Security Services Module-10

Model: ASA-SSM-CSC-10

Hardware version: 1.0

Serial Number: JAxxxxxxxxx

Firmware version: 1.0(11)2

Software version: CSC SSM 6.1 (Build#1519)

MAC Address Range: 001b.0ce2.4934 to 001b.0ce2.4934

App. name: CSC SSM

App. Status: Up

App. Status Desc: CSC SSM scan services are available

App. version: 6.1 (Build#1519)

Data plane Status: Up

Status: Up

HTTP Service: Up

MailService:up FTP Service: Up Activated: Yes

Mgmt IP addr: 10.x.x.x

Mgmt web port: 8443

Peer IP addr: <not enabled>

Can anyone please help with this issue

1 REPLY
Bronze

Re: CSC - Cant get access to management port

Your configuration is fine. Have you connected the cable to CSC management interface? You will need to connect cable to both, ASA and CSC, management interfaces.

291
Views
0
Helpful
1
Replies