Currently using SSL VPN via ASA 5510. Using the CSCO_WEBVPN_USERNAME and CSCO_WEBVPN_PASSWORD macro/variables with no problems in bookmarks and the values are pulled from the initial entries on the logon page perfectly.
I want to use the CSCO_WEBVPN_MACRO1 macro and set it to a RADIUS attribute but I cannot quite work out how this is achieved. Cisco docs advise that these values are Set through RADIUS/LDAP vendor-specific attributes but don't really detail how. Any one done this or have any ideas?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...