Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CSPM 3.0 failed to configure IPSec + NAT from PIX outside

We're experimenting to configure a a PIX from outside using CSPM 3.0. Without NAT (Address hiding), we can successfully communicate and deploy config from CSPM 3.0 to PIX. But when we try to add NAT (Address Hiding), we found that the CSPM failed to generate correct NAT (Address Hiding) configuration.

If we move the CSPM 3.0 to PIX inside, everything works fine.... We're using PIX 5.1

Rico

2 REPLIES
New Member

Re: CSPM 3.0 failed to configure IPSec + NAT from PIX outside

You’ll need to be inside to deploy the config. You might check with Cisco to see if they have some suggestions for you.

New Member

Re: CSPM 3.0 failed to configure IPSec + NAT from PIX outside

Hi there..

I have the same problem with you.....until now there is no solution...plz let me know..if you are succesful configuring IPSEC+NAT with CSPM....

regards

93
Views
0
Helpful
2
Replies