Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

CSPM 3.0 Reporting Problem

Hi all

I have problem with reports in CSPM 3.0 F

I get following reports (Summary Report=>Event Summary,Detailed Report=>Detailed Report) and some basic reports.. (Administrator activity and etc)

but i cant get Summary Report =>Network Traffic Summary,User Activitiy Summary,Most Active Users etc..,Detailed Report=>Detailed Network Event

Detailed User Activity etc..

I checked Tools=>Configure Notifications and seems all selected as Log..

And i had no problem regarding these reports before .First i encountered this problem at my customer after upgrading PIX 6.2(1) PDM 2.0(1)

and i suspected version upgrade and so i downgrared and tried again but problem existed.

I tried these at my company and i get same situation.

And idea ?

Thanks in advance

2 REPLIES

Re: CSPM 3.0 Reporting Problem

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

Community Member

Re: CSPM 3.0 Reporting Problem

Hi,

I have had this issue with CSPM version 2.3 and it turned out to be the syslog level that was set within the PIX. According to the following doc it should be set to Informational or Debug to get the level of reporting you require.

http://www.cisco.com/univercd/cc/td/doc/product/ismg/policy/ver30/topol/ch04.htm#xtocid2102517')">http://www.cisco.com/univercd/cc/td/doc/product/ismg/policy/ver30/topol/ch04.htm#xtocid2102517

102
Views
0
Helpful
2
Replies
CreatePlease to create content