I have a rule using CSPM to block port 135 and 4444 on the outside. The rule is the first one after the system generated rules. Yet it appears on the PIX with several policies below the rule. In order to deny these ports should the rule be just before the
deny any any statement for at the beginning of the access list ? Can I manually add this statement with out CSPM over writing it?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...