I am trying to configure our CSPM, but I've come across a little problem.
Our external router has an interface with a primary and secondary IP. The second IP has a split route tied to it leading to two gateways. When we do the topology wizard it picks up that the interface has two IP's, but will only allow us to enter the primary because the second IP is not in the same subnet as the primary. We've also tried to build the two networks off of two internet interfaces, but this still does not seem to work.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...