Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

cspm

in order to do an autodiscover while building the topology network you need to specify the telnet password. the cspm only asks for the telnet password. what if the device (a router for example)is configured to ask for a username and a password, then how would you configure the cspm to provide the username and the password not just the password in order for it to log on to the router.

1 REPLY
Silver

Re: cspm

Try username@password in the password field. That’s usually the correct syntax.

Good Luck

127
Views
0
Helpful
1
Replies
CreatePlease to create content