10-27-2008 01:27 PM - edited 02-21-2020 04:00 PM
I am working on a project to replace our VPN 3K with an ASA SSLVPN solution.
I am trying to get the downloadable access list (dACL) to work like it does on the VPN 3K.
I think i followed the steps necessary but, i have not had any success.
Any suggestions or help would be appreciated
10-28-2008 01:12 PM
i have it working to 5540 with acs. what is your question or issue.
10-28-2008 01:32 PM
Thank you for relying.
I have a dACL built on my ACS and i have assigned the dACL to my userID in ACS.
When I connect to my ASA with SSLVPN the route list in the anyconnect display is my full tunnel route not the one i have in my dACL.
I have radius running seemly, OK
So, my question is how to get the dACL to download with my userID.
Is there some setting i am missing in the setup of the; anyconnect profile or group policy.
This is my first attempt in setting up the ASA for SSLVPN.
Thank you again.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: