Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Cisco Employee

Debug command for IPSEC tunnel

Good morning,

I need to troubleshoot a IPSEC tunnel running on PIX between two sites.

The ping between the LANs loses some packets (could be 1% until 30%).

I think it is not a problem of the IPSEC tunnel, but I need to be sure about that.

WHat is a debug or show command where I can find out id the tunnel is up, from how long, how many of them, and if negotiation is successful.

I would like tu run also some debug but it must be not impacting the performances.

Any help appreciated.

Matteo

172
Views
0
Helpful
0
Replies
CreatePlease to create content