Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Debug IP Packet Output

Hi Guys, Can anyone interpret what these messages mean or point me to a place where i can get the interpretation:

IP: tableid=0, s=192.168.36.6 (local), d=192.168.36.254 (Vlan36), routed via RIB

IP: s=192.168.36.6 (local), d=192.168.36.254 (Vlan36), len 77, output feature, Check hwidb(63), rtype 1, forus FALSE, sendself FALSE, mtu 0

IP: tableid=0, s=192.168.36.6 (local), d=192.168.36.254 (Vlan36), routed via RIB

IP: s=192.168.36.6 (local), d=192.168.36.254 (Vlan36), len 313, output feature, Check hwidb(63), rtype 1, forus FALSE, sendself FALSE, mtu 0

IP: tableid=0, s=192.168.36.6 (local), d=192.168.36.254 (Vlan36), routed via RIB

The full message is attached below

Thanks

O.

2 REPLIES
Silver

Re: Debug IP Packet Output

1) Test another cable that you know it works instead of the one you have attached to the port.

2) Make sure the Speed and the Duplex configuration are the same in both points.

I think it does not affect the operation of the switch

New Member

Re: Debug IP Packet Output

The interfaces that I am getting those messages form are actually conected to a 100Mb ethernet leased lines

175
Views
0
Helpful
2
Replies
CreatePlease login to create content