Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Debugging and telnet

I've used telnet to access my Pix. When I issue the debug command, no debugging info is displayed. Why is this?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Debugging and telnet

Did you do "term mon", plus "logging console debug" and/or "logging monitor debug"? Do you have a terminal plugged into the console, cause some PIX debugs (debug packet for example) will automatically be sent there regardless of where you entered the command.

1 REPLY
Cisco Employee

Re: Debugging and telnet

Did you do "term mon", plus "logging console debug" and/or "logging monitor debug"? Do you have a terminal plugged into the console, cause some PIX debugs (debug packet for example) will automatically be sent there regardless of where you entered the command.

381
Views
0
Helpful
1
Replies