Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

debugging packets with ASA ver 7.2(2)

Hi,

Previously with PIX version 6.3 you could debug packets in realtime. i.e with the debug packet command.

Looking through the ASA 7.2(2) commands the debug packet command no longer exists. Though the packet-tracer command exists this is not in realtime.

Does anyone know how you debug packets with the ver 7.2(2).

Thanks

Brett

1 ACCEPTED SOLUTION

Accepted Solutions
Community Member

Re: debugging packets with ASA ver 7.2(2)

Create an ACL identifying the traffic you want to debug. Create a capture specifying the ACL and interface the traffic is entering.

Example:

access-list capture permit ip host x.x.x.x y.y.y.y

capture mycapture access-list capture interface inside

show capture mycapture detail dump

1 REPLY
Community Member

Re: debugging packets with ASA ver 7.2(2)

Create an ACL identifying the traffic you want to debug. Create a capture specifying the ACL and interface the traffic is entering.

Example:

access-list capture permit ip host x.x.x.x y.y.y.y

capture mycapture access-list capture interface inside

show capture mycapture detail dump

213
Views
0
Helpful
1
Replies
CreatePlease to create content