Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Destination NAT with PIX

Hi !

any ideas whether destination-nat is possible with a Cisco PIX ?

What I want to achieve is:

When the FW sees a packet, destined to a special IP, it will translate this packet - every other packet will remain "untouched".

Thx

Hans

1 REPLY
Community Member

Re: Destination NAT with PIX

You should be able to use NAT-0 with an access-list..

For example.

nat (inside) 0 access-list no-nat

nat (inside) 1 192.168.1.0 255.255.255.0 0 0

global (outside) 1 interface

access-list no-nat deny ip any host 192.168.1.1 (will be translated)

access-list no-nat permit ip any any (will NOT be translated).

149
Views
0
Helpful
1
Replies
CreatePlease to create content