I have vendors DMZd and I'm using the ASA DHCP function. The problem is the DHCP doesn't seem to release IP's. the scope starts at 10.10.10.50 and I'm up to 10.10.10.74 (which means I have had 24 vendors in the last four or five months)which creates a problem as I keep having to add the IPs to Websense. We only get one or two vendors using the DMZ per week. Lease time is set to 1600 seconds. Maybe I need to shrink to the scope from 10.10.10.50 - 10.10.10.250 to 10.10.10.50 - 10.10.10.60? Any ideas? If I shrank the DHCP scope would this force the ASA to reuse IP addresses? Thanks in advance
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...