I have 2600 modem with 2 port sync/async ports . i have configured 1 port sync and another port wirh async port.i have configured with DDR on async port with DLINK 56 kbps dialup modem (Not ISDN). my modem was not dialing.i used Cisco cable code no:
cab ss 232mt/ta . this cable is enough or i want use
cab ss 232mt . what is the difference between cab ss 232mt/ta and cab ss 232 mt
The focus of this board is Virtual Private Networks, however, there are a number of professionals online who may be able to assist you. We are always considering additional forums for such topics and I will make a note of your post.
If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at www.cisco.com/tac/caseopen
If anyone else in the forum can provide an answer, please reply to this thread.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...