Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Disabling PIX Interfaces...

I am reviewing a PIX configuration where two interfaces do not have IP addresses assigned to them ("no ip address"), but the interfaces have not been disabled using the "shutdown" keyword. Are there exposures in this instance due to the fact that the interfaces have not been "shutdown"?

Thank you.

1 REPLY
Silver

Re: Disabling PIX Interfaces...

there shouldn't be a problem - I am 99% certain that pixen disable all interfaces by default (or at least the non-inside ones), so that there are probably not commands because there have not been ones manually added, and thus they are still shutdown. What do you see on a show interface - if interface xxx is down, then it is down (line protocol up/down refers to whether there is a worknig cable plugged into it)

86
Views
0
Helpful
1
Replies
CreatePlease to create content