Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Disaster recovery for VPN 3005 concentrator

According to the document, if u upgrade twice for the software then the concentrator will have 2 copied of the image on 2 different flash.

If I upgrade the image and haft way through the concentrator hang up, how do I recovery back the previous image? Is it automatic?

regards,

Sam

1 REPLY
Bronze

Re: Disaster recovery for VPN 3005 concentrator

Hi,

you should be able to revert back to the last image w/o any problem, by following this procedure:

Correct affected VPN3000 concentrators by rebooting the concentrator, pressing Control G on the console, and toggling the software image back to the 2.5 or higher version of software.

To toggle the software image:

1. Attach a console to the concentrator.

2. Power cycle the concentrator.

3. After the message "Boot configured XXXMb of RAM.", look for three dots and then hit Ctrl-G (^G).

4. When Boot Menu Options appear, hit "5" to "Toggle active image."

5. Hit "1" to "Continue to load main code."

Thx

Afaq

85
Views
0
Helpful
1
Replies
CreatePlease to create content