Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Displaying Identity Settings

Hi All,

how can I check whether address or host is set for identity on both PIX506E and a 2600 Router.? show run doesn't seem to display and neither does show (crypto) isakmp policy. Cheers.

coolboarderguy...

2 REPLIES
New Member

Re: Displaying Identity Settings

By default, "address" is set as the identity. Hence it would not showup in any configs, Unless you manually add the statement again. But if you want to verify, you can launch the webbased PDM (Pix device Manager) and go to Configuration/VPN/IKE policies and see the present setting.

Gold

Re: Displaying Identity Settings

2600 router has ip address as the default isakmp identity; whereas pix 506e has hostname.

http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_command_reference_chapter09186a00801727a9.html#wp1027312

99
Views
0
Helpful
2
Replies
CreatePlease to create content