All of a sudden I'm no longer able to display the running config file of a PIX 515 v 6.3(4) in the usual way. In the past, after issuing the command "show run", the PIX will stop and prompt me "--More--" to press a key to continue. So either I have to press the space bar to show the next page, press Return to display one line and press any letter to quit. Now, the show run command will simply display from the beginning to end without stopping. How can I fix this and restored to the original setting? Thanks
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...