Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

distribution status

After pushing a configuration to the sensor, and verifying the distribution status for the sensor through the Command tab of the CSPM client, the commands/messages displayed were like those displayed of a connection status request effectuated against the Policy Server in the left pane of the Event Viewer:

... xxx.yyy.zzz 45000 1 [Established] sto:000 with version 1

Does anyone know why this happened??

2 REPLIES
New Member

Re: distribution status

I am confused...

Where did you see this message? In the CSPM event viewer pane?

Thanks,

-JB

New Member

Re: distribution status

No, through the Command tab of the CSPM client. The information displayed was similar to a connection status request when you place your mouce within the left pane of the event viewer, on one of the sensors, and then you right-click -and select connection status. In otherwords, what whas displayed was

... xxx.yyy.zzz 45000 1 [Established] sto:000 with version 1

instead of the usual information echoed about the distribution status of the pushed configuration. This is very odd.

163
Views
0
Helpful
2
Replies