Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

DMZ Setup

I have a server that needs to be added to my DMZ, however the server and the ASA are in two different buildings! The building are connected via fiber and I have vlan setup on both sides.

Is it possible to add the server to the DMZ w/o moving it?  I was thinking that maybe I could do this with Vlans - and setup intervlan routing.  Any ideas would help and thanks..

2 REPLIES

Re: DMZ Setup

Is the connection between your buildings layer 2 or layer 3? If it's layer 2, are you trunking?

Re: DMZ Setup

I have a server that needs to be added to my DMZ, however the server and the ASA are in two different buildings! The building are connected via fiber and I have vlan setup on both sides.

Is it possible to add the server to the DMZ w/o moving it?  I was thinking that maybe I could do this with Vlans - and setup intervlan routing. Any ideas would help and thanks..

Hi,

For this you need to have connectivity between the building via l2 or l3,if l2 then allow the dmz vlan over the trunk so that same vlan will be available at other building,in this case it will be layer 2 connectivity where your ASA is also residing and they will come under same segment.

Hope to help!!

Ganesh.H

459
Views
0
Helpful
2
Replies
CreatePlease to create content