Guys Im trying to setup Guest access for our visitors.
I have 4 internal controllers up and running with v4.1.185 and no issues. We have just purchased an additional WLC that we want to setup on our DMZ for guest access.
We have done all required Anchor/Mobility configurations on all controllers (Internal & DMZ). I can ping to/from the internal controllers to the DMZ controller with no issues. But my mpings and epings are failing and my data and control paths are not all up. Im pretty sure that this is a PIX issue not allowing the correct ports to/from the controllers. Iam not a security guy ao Im a little confused on what configs need to happen on the PIX to allow these ports. Can someone please assist me with the PIX configurations?
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...