Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Do you need NAT for a L2L VPN

Hi all,

I have to create a L2L VPN tunnel between us and another local carrier. We are using a 3845 router and the other carrier is using a 3745 router. I have created many VPN tunnels in the past using NAT. In this case I don't have to. Is it possible for a VPN tunnel to work with the same configuration without using NAT. My router and the device being connected to all have a public IP address in the same subnet.

Thanks,

Stevan

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Do you need NAT for a L2L VPN

Hi,

Yes, you can create L2L without having to use NAT.

Check the configuration examples (under Site-to-Site VPN with PIX/IOS):

http://www.cisco.com/en/US/partner/products/hw/vpndevc/ps2030/prod_configuration_examples_list.html

Before this, you probably has many experience configuring tunnel as shown in the url below:

http://www.cisco.com/en/US/partner/tech/tk583/tk372/technologies_configuration_example09186a00800949ef.shtml

Rgds,

AK

2 REPLIES

Re: Do you need NAT for a L2L VPN

Hi,

Yes, you can create L2L without having to use NAT.

Check the configuration examples (under Site-to-Site VPN with PIX/IOS):

http://www.cisco.com/en/US/partner/products/hw/vpndevc/ps2030/prod_configuration_examples_list.html

Before this, you probably has many experience configuring tunnel as shown in the url below:

http://www.cisco.com/en/US/partner/tech/tk583/tk372/technologies_configuration_example09186a00800949ef.shtml

Rgds,

AK

114
Views
0
Helpful
2
Replies
CreatePlease to create content