Hi the PIX does support route-map but it is only for redistribution of routes between RIP and OSPF. If you have 2 routers .. Why don't you configure them using HSRP ( if they are cisco ) or VVRP which ius standard to provide redundancy between the two ..
A good way to achieve this if you don't want to configure your routers in HSRP mode, is to configure 2 static routes on your PIX FW with 2 different administrative distances; where the lower distance is for router a (i.e. the primary) and the other static route is for router b. When router a fails, the PIX will route the traffic through router b. Example:
If I'm understanding you correctly, you have your PIX connected to 6509 and the 6509 is connected to two GSR. If so, then the default route on your PIX should be only to the 6509 and on your 6509 you can do policy-based routing if required.
If this is not the case please clarify your setup more so we can help you.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...