Does VPNClient3 to PIX506 v6.0(1) through 2501 work?
Reading these messages it seems that there are things that don't work yet. Is it possible for a VPNClient3 to get to a network protected with a PIX506 v6.0(1), with a Cisco2501 router between the PIX and the ISP's Kilostream line?
Protocols 50 and 51 and udp port 500 are open on the router, but it still won't connect. If this combination won't work I'll stop trying to make it work! What do I need instead?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...