It is true that if you use the manual CLI to define authorizations you cannot do HTTPS. You can only do HTTP, FTP, and Telnet. However, the per-user ACL download places the ACL on the interface you authorizing on. This creates a temporary ACL on the input of that interface for that user/ip-address which allows you to define anything you would normally define in an interface ACL.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...