Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

DRAM on PIX515E

Is there any type of command that I can use to determine my DRAM configuration. I would like to do this without opening the box.

I want to know if I have two 16MB modules or one 32MB module. As well on another, do I have two 32MB modules or one 64MB module.

Thanks,

Joshua

3 REPLIES
New Member

Re: DRAM on PIX515E

show version

Gold

Re: DRAM on PIX515E

below is a "sh ver" output as an example:

CISCO xxx (xxxxxx) processor (revision 0x500) with 44237K/4915K bytes of memory.

Processor board ID xxxxxx (xxxxxx), with hardware revision 0000

CPU rev number 7

Bridging software.

1 Ethernet/IEEE 802.3 interface(s)

1 ATM network interface(s)

128K bytes of non-volatile configuration memory.

12288K bytes of processor board System flash (Read/Write)

2048K bytes of processor board Web flash (Read/Write)

Configuration register is 0x2102

with the first entry above, "CISCO xxx (xxxxxx) processor (revision 0x500) with 44237K/4915K bytes of memory." 44237K + 4915K = 48MB of memory

Cisco Employee

Re: DRAM on PIX515E

"show version" command would show you how much of total RAM you have on your Pix and NOT how many modules you have on your pix. You need to open up the pix to check the number of modules yourself.

Rahul Pathania

rpathani@cisco.com

131
Views
0
Helpful
3
Replies